You can save configurations for easy selection and use.
Warning
Be careful, configurations are linked to the trimmers. For example, a configuration saved for Fotoba cannot be used for Kala.
Add a trimmer configuration
- On the Page Setup/Marks tab/Trimmers area, click on the Edit… button:
- Set your Trimmer as you need it.
- On the bottom of the window, click on the new configuration button:
Info
While the Trim-O-Matik window is different for each trimmer, the lower part of the window, including the buttons for saving settings and action buttons, is the same for all trimmers.
- Then type the configuration’s name and click on OK.
- It will then appear in the trimmer configuration’s list. This list is shared with all CalderaRIP modules.
Edit a trimmer configuration
To edit a configuration, select it from the list then click the Edit... button. The trimmer window will open with your specific configuration settings. You can change the parameters and save the changes by clicking on OK or Apply.
If you have just set a configuration and want to apply changes to another one, you can directly select it at the top of the Configuration window.
When you select a configuration, it becomes the current configuration and its parameters are displayed: you can then go from one configuration to another, without returning to the module.
Delete a configuration
To delete a configuration, select it from the list and click Edit...
Then click on the trash can button at the lower part of the window. You will be asked to confirm the deletion: