Applies to the V10.2a or newer drivers for the FujiFilm UViStar Pro8 and Pro8W.
Orange and Blue inks instead of the light colors.
Instructions:
1) First, add new inks (Orange and Blue) then add a new inkset CMYKcmOB in EasyMedia (click "Edit Inksets")
2) If the inks are installed in this order (i.e. if O replaces LY and B replaces LK) then just print like that, it should work.
3) Otherwise, put in inks in the right order in the Ink Remapping window.
Note that:
- The separations (in the ripped folder) will still be named "LY" and "LK", because the controller needs these names.
- CMYKcmOB above is just an example, you can replace any light ink by any other process ink (however you always have to use 8 inks total)
- In EasyMedia, in the first step "Transitions" (between Light and Dark inks), you *must* select "Run Wizard" (Print/Measure/Build) and not "Use Matan optimized transitions". The Matan curves will work only in CMYKcmyk.