Supported models
- This driver can be used for flatbed cutters compatible with .dxf files
- Dimensions: 3032mm and 2516mm
Driver
- Innohue Flatbed
Driver history
-
CalderaRIP V17.3
- A new "Add direction mark" checkbox was added to the Misc. area of the Cutter Tools Configuration for almost all cutting drivers (both GrandCut and VisualCut). Activating this new field adds direction marks in the form of a triangle pointing to the bottom edge of the cut job, which significantly speeds up the operators' work when managing these files.
-
CalderaRIP V16.3
- Driver supported since this version
Installation
Type of license
| CutServer | |
| GrandCut A |
This driver is for flatbed / GrandCut cutters, so you might want to read:
Format
Supports .dxf and .dxf R14 (bezier curves)
Marks type
- Cross
Features
Info
Please refer to this article to have information about the standard features available in the Cutter Tools Configuration window.
Specific features
- Bottom-right origin: Origin will be placed at the bottom-right position instead of the bottom-left default position to suit your table's orientation
- CCW auto rotation: Auto-rotation will go in a counter-clockwise direction, rather than clockwise
- DXF R14 (Bezier support): Use a newer version of DXF language which supports Bezier curves and leads to a smoother result
Associations
- No materials and methods association
- No materials and media association
- No methods and contours association
Cut contour names from your print file are directly included in the exported .DXF cut file
Recommendations
If your production requires it, you may use third-party software to check measurements. Caldera recommends you use the open-source LibreCad.