Supported models
- CG-75FXII Plus: 90mm-1,040mm (3.54"-40.9")
- CG-130FXII Plus: 90mm-1,580mm (3.54"-62.0")
- CG-160FXII Plus: 90mm-1,880mm (3.54"-74")
Driver
- Mimaki CG-FXII Plus
Driver history
-
CalderaRIP V14.0:
- The Mimaki CG-FXII Plus series is supported starting with this version.
Installation
Info
In the past, different cutting devices required separate licenses: CutServer for roll-to-roll cutters, GrandCut (A or B) for flatbed cutters, and a cut option for trimmers. This resulted in different installation methods depending on the device.
Today, annual subscribers and perpetual license holders with CalderaCare can use any CalderaRIP‑supported cutting device without an additional license.
| Roll-to-Roll (Legacy CutServer) | |
| Flatbed (Legacy GrandCut A/B) |
You might be interested in reading:
Marks
Mimaki Edge registration Marks:
Mimaki IDCut:
Features
VisualCut Interface
The following options are available in the VisualCut interface:
- USB connection
- Ethernet connection
- Sheet Off option
For more information, please refer to this article.
Cutter Tools Configuration
Custom Margins capabilities:
- Left margin
- Left marks offset
- Horizontal/Vertical spacing
- Horizontal/Vertical size
- Thickness
The Auto rotate job option is available from the Cutter tools configuration (note that you need to enter your Cutter Limits - width and height).