When using ARTPath, CalderaRIP supports XML as the output format.
Installation
Info
In the past, different cutting devices required separate licenses: CutServer for roll-to-roll cutters, GrandCut (A or B) for flatbed cutters, and a cut option for trimmers. This resulted in different installation methods depending on the device.
Today, annual subscribers and perpetual license holders with CalderaCare can use any CalderaRIP‑supported cutting device without an additional license.
| Roll-to-Roll (Legacy CutServer) | |
| Flatbed (Legacy GrandCut B) |
You may refer to the guide: "How to install a flatbed cutter?". During the installation process, make sure to select the Gerber driver.
Configuration
To enable XML output for the Gerber driver:
- Open Terminal.
-
Enter the following command and press Enter:
touch /opt/caldera/lib/shared/GerberXML.conf