Supported models
| Mimaki CG-AR Series | |||
| CG-60AR (photo) | CG-100AR | CG-130AR | |
| Sheet size: | 90 - 740 mm (3.5 - 29.1") | 90 - 1,250 mm (3.5 - 49.2") | 90 - 1,550 mm (3.5 - 61.0") |
Driver
- Mimaki CG-AR
Driver history
-
CalderaRIP V16.1:
- Mimaki CG-AR cutters supported since this version
Installation
Info
In the past, different cutting devices required separate licenses: CutServer for roll-to-roll cutters, GrandCut (A or B) for flatbed cutters, and a cut option for trimmers. This resulted in different installation methods depending on the device.
Today, annual subscribers and perpetual license holders with CalderaCare can use any CalderaRIP‑supported cutting device without an additional license.
| Roll-to-Roll (Legacy CutServer) | |
| Flatbed (Legacy GrandCut A/B) |
You might be interested in reading:
Marks
Marks are specific to Mimaki and not compatible with other cutters:
Mimaki ID cut numbers are applicable from Page setup > Cutting tab, under the Barcodes area.
Features
VisualCut Interface
The following options are available in the VisualCut interface:
- Paneling
- Sheet off
For more information, please refer to this article.
Cutter Tools Configuration
The Auto rotate job option is available from the Cutter tools configuration.
Associations
- No materials and methods association
- No materials and media association
- No methods and contours association
Connection
| USB | |
| File | |
| Network | |
| Serial |