Articles in this section

Dgen Teleios Grande H6 - Overview

Updated November 18, 2025 15:01

Model supported

3.3m direct-to-fabric printer
CMYK 6 x 2 colour
Visit the official website of DGI / Dgen

Driver

DGen-Teleios-Grande-H6

Driver history

CalderaRIP V11.0:
- Revision A: Fixed a bug that caused multicopy to fail in RawIP connections.
CalderaRIP V10.2:
- Revision X: The drop sizes for 3D modes have been changed from 7/14/21 to 7/20/32, resulting in an approximate 20% reduction in ink consumption reported by CostProof.
  
  Warning
  
  This change will not retroactively affect previously ripped jobs.
CalderaRIP V10.2:
- Printer supported from this version.

Resolutions

Production_1Pass-1D
Production_1Pass-3D
Production 2Pass-1D
Production_2Pass-3D
Production_3Pass-1D
Production_3Pass-3D
Production_4Pass-1D
Production_4Pass-3D
Production_6Pass-1D
Production_6Pass-3D

Production_8Pass-1D
Production_8Pass-3D
Quality_1Pass-1D
Quality_1Pass-3D
Quality_2Pass-1D
Quality_2Pass-3D
Quality_3Pass-1D
Quality_3Pass-3D
Quality-4Pass-1D
Quality_4Pass-3D

Quality_6Pass-1D
Quality_6Pass-3D
Quality_8Pass-1D
Quality_8Pass-3D

Inks

Info

Printer driver(s) compatible with Custom Inksets. For more information, partners and resellers should consult the Partners Portal; end users can find details on our website.

Cyan
Magenta
Yellow
Black
Light Cyan
Light Magenta

This driver can use a penetration ink called SPC (Stylish Printing Control) as a Spot Ink. To configure it, you need to go to the Page Setup module:

Then go to the SPC tab and click Enable separation. You can use the default method (Ink Penetration) and values or customize them according to your production needs.

To learn more about the general process for using spot inks, please visit the dedicated article.

Connection

	USB
	File
	Network
	Serial