Supported models
|
|
|
|
||
If you have any of the following models, please refer to their specific documentation:
Driver
- Mimaki (generic driver)
Driver history
-
CalderaRIP V9.20:
- The Mimaki generic driver is supported since this version
Installation
Info
In the past, different cutting devices required separate licenses: CutServer for roll-to-roll cutters, GrandCut (A or B) for flatbed cutters, and a cut option for trimmers. This resulted in different installation methods depending on the device.
Today, annual subscribers and perpetual license holders with CalderaCare can use any CalderaRIP‑supported cutting device without an additional license.
| Roll-to-Roll (Legacy CutServer) | |
| Flatbed (Legacy GrandCut A/B) |
You might be interested in reading:
Marks
Standard barcode numbers are applicable from Page setup > Cutting tab, under the Barcodes area.
Features
VisualCut Interface
The following options are available in the VisualCut interface:
- Rewind at end
- Sheet off
For more information, please refer to this article.
Cutter Tools Configuration
The Auto-rotate job option is available from the Cutter tools configuration.
Methods and Material Associations
- No materials and methods association
- No materials and media association
- No methods and contours association by material
Despite the above, you can use the tools list to associate contour names with a given tool. If more than one material is used, you can save and reload different tool lists.
Connection
Info
All models support USB. The CG-SRIII series also supports Ethernet, but please refer to Mimaki documentation directly for more information.
| USB | |
| File | |
| Network | |
| Serial |
Tips & tricks
Cutting procedure to prevent the detection of duplicate marks
- Insert the media
- Select Roll (Back)
- Cancel marks detection with "End"
- Position the tool in the bottom-left mark (inside the "square")
- Set the origin with "Enter" or "Origin"
- Single with marks
- Rotate the job in VisualCut as you see it when in front of the cutter
- Cut