1. Caldera HelpDesk
  2. CalderaRIP
  3. What's new?

Articles in this section

CalderaRIP v20 - Changelog

Updated

November 2026

Version 20.0.0

New

Operating system: Added compatibility with macOS 27 Golden Gate.

  Info

If you’re already running macOS 27 Golden Gate, you may be prompted to install Rosetta after upgrading the software. Learn more.
   
Improved

Multilayer: 

  • Improved support for opening standard multilayer PDF files without embedded job settings. You can now select a layer arrangement compatible with the file’s layer count and the printer, while valid embedded configurations are still applied automatically:
    CalderaRIP v20, layers arrangement improv.png
  • Added support for adjusting image size and position on the media, and using all Page Setup actions in the left panel except “Mirror” for standard multilayer files. All layers remain aligned and in the same orientation.
   
Removed
 Operating system: Removed support for macOS 14 Sonoma.
   
Fixed

Interoperability: Fixed inaccurate printing times reported to CalderaCloud for completed print jobs.

  Info

CalderaCloud is a web-based platform for monitoring production activity across connected Caldera environments. It is not yet available in CalderaDock, but support is planned; see the dedicated documentation for more information.
   
Fixed

Print Management: 

  • Fixed an issue where a “Too many open files” error could cause the printer driver to crash while executing print jobs.
  • Fixed an issue that prevented nesting margins from being applied to print jobs sent to HP printers.
   
Fixed
 Spooler: Fixed an issue preventing rasterization job preview files from being deleted when the Enable Cutting Contour feature was enabled.
   
Fixed

User Experience: 

  • Fixed Fileman not restoring its window size and Spooler not restoring its window position and size when reopened.
  • On macOS 26 Tahoe, fixed slow image loading in driver main windows when many layer configurations had been created.
   
Fixed
 VisualCut: Fixed repeated selection of the same file applying “Force 180 degrees” more than once and changing the job orientation.

 

Printer drivers

Fixed
 Epson SureColor P10000 and P20000: Fixed deviations in roll cutting when the Cut After Print feature was enabled.
   
Fixed
 HP Latex 730 W and 830 W: Fixed an issue that caused the top margin to be missing from the fifth layer of five-layer jobs when the Enable Cutting Contour feature was enabled.

 

Now included in the full installer:

   

 

Cutter drivers

Improved
 Comagrav: Added support for registration marks beyond the four-corner setup to improve scanner consistency and alignment.
   
Fixed
 Graphtec FC9000: Fixed the configured cut-mark background not being applied to the Cut ID in previews and printed output.
   
Fixed
 HP Latex: Fixed code-reading failures caused by insufficient spacing between Barcode 39 or QR codes and the cutter’s PostNet barcode or identification number.
   
Fixed
 Kongsberg JDF: Fixed insufficient spacing between QR codes and ID numbers in cut files.
   
Fixed
 Secabo DTF MultiCut Pro: Fixed leading zeros being removed from QR code and barcode identifiers.
   
Fixed

Summa S Series:

  • Fixed code-reading failures caused by insufficient spacing between Barcode 39 or QR codes and the cutter’s PostNet barcode or identification number.
  • Fixed barcode identification numbers appearing only at the bottom of files instead of on all four sides.
Was this article helpful?
0 out of 0 found this helpful